Plant Coursework

My DT GCSE coursework was based around designing a modern compact plant holder that could potentially integrate the same circuitry as my 'Biology Plant Monitor' project.

It was made with a variety of different manufacturing techniques including 3D routing foam, 3D printing and alumnium manipulation. The roof of the product was a gutter that had been spray painted! LEDs were also fitted to showcase the plants on display. In the end, the final product looked clean and modern ideal for the client set out at the beginning.

The project was awarded 100% as the final moderated mark.

Some of the design slides (full document here - sensitive data redacted) (the whole project was approx. 40 pages long):

Final product: